In-House Electronics Manufacturing (EMS)
SMT/THT assembly, box-build and testing — manufactured and validated on our own floor.
Our in-house EMS turns electronic designs into production-ready products — from prototype assembly and validation to low-, medium- and high-volume production.
Advanced manufacturing, stringent quality control and complete traceability mean faster time-to-market, optimised costs and consistent quality, batch after batch.
Core capabilities.
SMT & THT Assembly
High-mix surface-mount and through-hole assembly, in-house.
Box-Build Assembly
Full product integration — boards, harnesses, enclosure and labelling.
Functional Testing & QA
Test fixtures, AOI and functional QA on every unit.
Prototyping & NPI
Fast prototype runs and a smooth path to new-product introduction.
Supply Chain & Sourcing
Component sourcing, BOM management and obsolescence handling.
Compliance & Certification
Builds that meet recognised quality and compliance standards.
Everything under one roof.
PCB Assembly (PCBA)
- SMT assembly
- THT assembly
- Mixed-technology assembly
- Single & double-sided
- Multi-layer assembly
- Fine-pitch & BGA
- Prototype to high-volume
- Rework & repair
Quality Assurance
- Automated Optical Inspection (AOI)
- X-Ray inspection
- Visual inspection
- Solder-joint inspection
- IPC standard compliance
Functional Testing & Validation
- Functional & electrical testing
- Firmware verification
- Interface & protocol testing
- System-level testing
- Reliability verification
Design Verification Testing (DVT)
- Electrical & functional verification
- Thermal & environmental testing
- Mechanical validation
- Signal-integrity testing
- EMI/EMC pre-compliance
Production Testing
- Automated functional test (AFT)
- In-circuit & flying-probe test
- Firmware programming
- Calibration
- Burn-in testing
- Final quality inspection
Component Sourcing & Procurement
- Component sourcing
- Approved-vendor management
- Component verification
- Alternate selection
- Obsolescence management
- Traceability
Manufacturing Support
- Production planning
- Work instructions
- Process development & optimisation
- Production scaling
- Technical support
Product Lifecycle Management
- Design transfer & NPI
- Production ramp-up
- Component obsolescence
- Revision & documentation control
- End-of-life planning
Engineering Change Management
- ECR / ECO
- Revision control
- BOM management
- Change validation & traceability
The stack we work in.
Need boards built and tested?
Tell us what you're building. We'll bring the engineering and the in-house manufacturing.